Bosch WAT28402UC Dimensions, Clearances & Fit Guide

This guide provides all the key measurements for the WAT28402UC washing machine. Review dimensions, clearance requirements, door swing, pedestal and stacking options, and installation notes to ensure a proper fit in your home.

Key Dimensions

Width23.5 in
Height33.25 in
Depth25 in
Depth w/ Door Open 90°42.5 in
Capacity2.2 cu. ft.
Weight160 lb
ADA CompliantYes (when installed on pedestal)
ENERGY STAR® CertifiedYes
Front View Front-Load Washer Dimensions
Side View Front-Load Washer Dimensions

Clearance Requirements

Front View Front-Load Clearance for Washer
Side View Front-Load Clearance for Washer
Front21 in
Sides0.5 in
Rear5 in
Top1 in
Proper clearance ensures safe operation, reduces vibration, and allows for adequate airflow. Always maintain the minimum space on all sides to prevent overheating and to make servicing easier.

Door Swing & Accessibility

Front-Load washer Door Swing
Door SwingLeft-hinged (non-reversible)
Door Swing Maximum140°
Allow room for full door swing.
Meets ADA accessibility standards.

Pedestal & Stacking Compatibility

Pedestal compatible
Pedestal CompatibleYes
Models
  • WMZ20490
Stackable compatible
StackableYes
Stacking KitWTZ20410UC

Installation Notes

Flooring & Leveling
  • Solid, level surface
  • Concrete preferred
  • Level all four feet
Drain & Plumbing
  • Drain height: 24–39 in
  • High‑quality stainless‑steel hoses recommended
Electrical
  • 240V 60 Hz AC only
  • 15 amp circuit
  • NEMA 6-15 (3-prong 240V)
  • Accessible plug required
Service Access
  • Water supply accessible
  • Drain connection accessible
  • Maintain rear access for water, drain, and electrical connections.

How the WAT28402UC Fits Within Bosch’s Lineup

The Bosch WAT28402UC is part of the premium 800 Series compact washer lineup, featuring AquaStop Plus leak protection, EcoSilence motor, and a 2.2 cu. ft. capacity. It offers 15 wash cycles including Sanitize and Super Quick 15 Min, operates at a quiet 50 dBA during wash cycles, and achieves a maximum spin speed of 1,400 RPM. Although discontinued, it remains widely installed in condos and small homes, making accurate dimensions and clearance information essential for replacement planning.

FAQ About This Washer

The WAT28402UC is an 800 Series model with premium features including AquaStop Plus leak protection, while the 28400UC is a 300 Series model and the 28401UC is a 500 Series model.

Yes. It stacks with any 24‑inch Bosch dryer using the WTZ20410UC stacking kit. Minimum stack height is 67-3/4 inches.

No special ventilation is required, but Bosch specifies at least 5 in of rear clearance for hoses and airflow.

No. The door is permanently left‑hinged and cannot be reversed.

A minimum of 43 in is recommended to accommodate the 42.5 in door‑open depth and rear clearances.

Yes, as long as the drain height is between 24 and 39 inches.

Yes, but Bosch recommends a solid floor surface and proper leveling to minimize vibration. For wooden floors, reinforce with a water-resistant board (min 1.18 in/30 mm thick). [citation:6]

A dedicated 20-amp circuit is recommended if plugged into an individual circuit, but a 15-amp shared circuit is acceptable.

The washer requires a 240V NEMA 6-15 outlet (3-prong).

Yes, provided all clearances are maintained and the front remains unobstructed for airflow and service.

Yes. Bosch continues to supply parts and service support for this model even though it is discontinued.

Yes. Meets ADA height and access requirements when installed on pedestal, and meets ADA operable parts requirements for controls and detergent dispenser.

AquaStop Plus provides extra protection against water damage, combining the AquaStop base with AquaShield hoses.

Copyright 2026. All rights reserved.