Electrolux Washer - E25 Error Code

The control board received an invalid or unexpected signal.

Meaning

The control board received an invalid or unexpected signal.

The Electrolux E25 error code indicates that the washer’s microprocessor received an invalid, out-of-range, or contradictory signal from one of its monitored components. This is a general electrical fault that may involve the pressure sensor, drain pump, inlet valve, motor, or internal wiring. E25 is less common than E20–E24 and typically points to intermittent wiring faults, moisture intrusion, or a failing control board.

Symptoms

  • Washer stops mid-cycle
  • Random or inconsistent error behavior
  • E25 appears intermittently
  • Washer may fail to start certain cycles

Causes

  • Loose or corroded wiring harness
  • Moisture on the control board
  • Faulty pressure sensor or pump feedback
  • Failing control board microprocessor
🔧

Step-by-Step Fixes

  • Inspect all wiring harnesses for looseness or corrosion.
  • Check the pressure sensor and drain pump for stable readings.
  • Dry the control board area if moisture is present.
  • Replace the control board if the error persists.
⚠️

Safety Notes

  • Disconnect power before accessing internal electronics.
  • Do not operate the washer if electrical burning smells are present.
📋

Applicable Models

Show Models
  • EFLS627UTT
  • EFLS527UTT
  • EIFLS60LT
  • EW6F3143EB
  • EW7F3846QF
📁

Related Pages

📁

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On EU PerfectCare models, E25 may appear after power fluctuations or moisture exposure near the control board.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Was this page helpful?

Copyright 2026. All rights reserved.