Electrolux Washer - 29 Error Code

The washer detected a calibration error in the water level sensor.

Meaning

The washer detected a calibration error in the water level sensor.

Error 29 indicates that the pressure sensor calibration is incorrect or unstable. Commercial Electrolux washers rely on precise calibration for dosing, heating, and safety. If calibration drifts or becomes corrupted, the washer halts operation.

Symptoms

  • Washer stops during fill
  • Water level readings appear inconsistent
  • Error 29 appears early in cycle

Causes

  • Pressure sensor calibration drift
  • Blocked pressure hose
  • Control board calibration error
πŸ”§

Step-by-Step Fixes

  • Inspect pressure hose.
  • Reset the washer.
  • Replace pressure sensor if calibration cannot be restored.
⚠️

Safety Notes

  • Disconnect power before servicing.
πŸ“‹

Applicable Models

Show Models
  • W465H
  • W465H2
  • WH6-20
πŸ“

Related Pages

πŸ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On W465H models, Error 29 may appear after power fluctuations affecting calibration memory.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.