Electrolux Washer - 40 Error Code

The washer detected an overvoltage condition.

Meaning

The washer detected an overvoltage condition.

Error 40 indicates that the washer detected voltage above the safe operating range. Commercial Electrolux washers monitor incoming voltage to protect the inverter, control board, and heating system. Overvoltage can cause catastrophic component failure if not detected.

Symptoms

  • Washer shuts down suddenly
  • Error 40 appears at startup or mid-cycle
  • Electrical humming or relay clicking

Causes

  • Facility voltage too high
  • Power surge
  • Faulty voltage regulator
πŸ”§

Step-by-Step Fixes

  • Verify facility voltage is within Electrolux specifications.
  • Inspect power connections.
  • Install surge protection.
⚠️

Safety Notes

  • Do not operate washer during electrical instability.
πŸ“‹

Applicable Models

Show Models
  • W465H
  • W465H3
  • WH6-20
πŸ“

Related Pages

πŸ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

Error 40 is common in facilities with unstable three-phase supply.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.