Electrolux Washer - E10 Error Code

The washer is not receiving water at the expected rate.

Meaning

The washer is not receiving water at the expected rate.

The Electrolux E10 error code indicates that the washer is not filling with water fast enough or at all. Electrolux washers monitor water flow and pressure; if the water level does not rise within a defined time window, the control module triggers E10. This is typically caused by clogged inlet filters, low household water pressure, kinked hoses, or a faulty inlet valve. E10 is one of the most common Electrolux washer errors and applies to nearly all modern Electrolux front-load models.

Symptoms

  • Washer takes too long to fill
  • No water entering the drum
  • Washer stops early in the cycle
  • E10 displayed shortly after pressing Start

Causes

  • Clogged inlet screens
  • Kinked or frozen inlet hoses
  • Low household water pressure
  • Faulty water inlet valve
πŸ”§

Step-by-Step Fixes

  • Clean the inlet screens on both hoses.
  • Ensure both hot and cold water valves are fully open.
  • Straighten any kinks in the hoses.
  • Check for frozen hoses in cold climates.
  • Test the inlet valve for proper operation.
⚠️

Safety Notes

  • Turn off water supply before removing hoses.
πŸ“‹

Applicable Models

Show Models
  • EFLS627UTT
  • EFLS527UTT
  • EFLS210TIW
  • EFLW317TIW
  • EIFLS60LT
  • EWF1282
  • EW6F3143EB
  • EW7F3846QF
  • EW8F2966CB
  • EWF8024Q5WB
πŸ“

Related Pages

πŸ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On EFLS627 models, E10 may appear if the Perfect Steam feature activates before sufficient water enters the drum.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.