Electrolux Washer - E24 Error Code

The control board detected a drain pump triac circuit failure.

Meaning

The control board detected a drain pump triac circuit failure.

The Electrolux E24 error code indicates a failure in the drain pump triac control circuit. The triac is an electronic switch on the control board that regulates power to the drain pump. If the triac is shorted, open, or unable to switch correctly, the washer cannot safely activate the pump. E24 is more severe than E20–E22 because it points to an electrical or control board malfunction rather than a simple blockage.

Symptoms

  • Washer will not drain
  • Pump does not activate at all
  • E24 appears immediately when draining should begin
  • Washer may shut down for safety

Causes

  • Shorted drain pump
  • Triac failure on the control board
  • Burned or loose wiring harness
  • Moisture damage to the control board
πŸ”§

Step-by-Step Fixes

  • Test the drain pump for proper resistance and shorts.
  • Inspect wiring between the pump and control board.
  • Check the control board for burn marks or corrosion.
  • Replace the control board if the triac is defective.
⚠️

Safety Notes

  • Disconnect power before testing electrical components.
  • Do not continue running the washer if the pump does not activate.
πŸ“‹

Applicable Models

Show Models
  • EFLS627UTT
  • EFLS527UTT
  • EIFLS60LT
  • EW6F3143EB
  • EW7F3846QF
πŸ“

Related Pages

πŸ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On EFLS models, E24 often appears after a pump motor short that damages the triac on the control board.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.