Electrolux Washer - E31 Error Code

The pressure sensor is reporting invalid or unstable water level readings.

Meaning

The pressure sensor is reporting invalid or unstable water level readings.

The Electrolux E31 error code indicates that the washerโ€™s pressure sensor (water level sensor) is sending invalid, unstable, or out-of-range signals to the control board. Electrolux washers use an analog pressure sensor connected to a thin rubber hose. If the hose becomes blocked, the sensor becomes contaminated, or the wiring is loose, the washer cannot determine the correct water level and triggers E31. This code appears only on models equipped with analog pressure sensors.

Symptoms

  • Washer stops mid-cycle
  • Water level fluctuates unexpectedly
  • Washer may overfill or underfill
  • E31 appears during fill or wash

Causes

  • Blocked or kinked pressure hose
  • Faulty pressure sensor
  • Detergent residue in the pressure chamber
  • Loose wiring to the sensor
๐Ÿ”ง

Step-by-Step Fixes

  • Inspect the pressure hose for blockages or kinks.
  • Remove the hose and blow through it to confirm it is clear.
  • Check wiring to the pressure sensor.
  • Replace the pressure sensor if readings remain unstable.
โš ๏ธ

Safety Notes

  • Disconnect power before servicing internal components.
๐Ÿ“‹

Applicable Models

Show Models
  • EFLS627UTT
  • EFLS527UTT
  • EIFLS60LT
  • EW6F3143EB
  • EW7F3846QF
  • EWF8024Q5WB
๐Ÿ“

Related Pages

๐Ÿ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On EU PerfectCare models, E31 often appears when detergent residue accumulates in the pressure chamber after repeated low-temperature cycles.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.