Electrolux Washer - E44 Error Code

The washer is not receiving proper feedback from the door lock.

Meaning

The washer is not receiving proper feedback from the door lock.

The Electrolux E44 error code indicates that the control board is not receiving the correct locked/unlocked feedback signal from the door lock assembly. Even if the lock engages mechanically, the washer will not proceed unless the feedback switch confirms the locked state.

Symptoms

  • Washer will not start
  • Door locks but washer does not run
  • E44 appears after pressing Start

Causes

  • Faulty door lock feedback switch
  • Loose wiring
  • Control board input fault
๐Ÿ”ง

Step-by-Step Fixes

  • Inspect wiring to the door lock.
  • Replace the door lock assembly if the feedback switch is defective.
โš ๏ธ

Safety Notes

  • Disconnect power before servicing.
๐Ÿ“‹

Applicable Models

Show Models
  • EFLS627UTT
  • EFLS527UTT
๐Ÿ“

Related Pages

๐Ÿ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On EU PerfectCare models, E44 may appear intermittently due to vibration loosening the feedback connector.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.