Electrolux Washer - E60 Error Code

The washer detected a general heating system fault.

Meaning

The washer detected a general heating system fault.

The Electrolux E60 error code indicates a general heating system malfunction. This umbrella code covers multiple heating-related issues, including failed heating elements, faulty NTC temperature sensors, wiring problems, or control board heating circuit faults. Some Electrolux models display more specific heating codes (E61, E62), but many units use E60 as the primary heating error.

Symptoms

  • Washer runs with cold water
  • Cycles take longer than normal
  • E60 appears mid-cycle
  • Washer may stop before final spin

Causes

  • Faulty heating element
  • Defective NTC temperature sensor
  • Loose or burned wiring
  • Control board heating relay failure
πŸ”§

Step-by-Step Fixes

  • Test the heating element for continuity.
  • Inspect wiring to the heater and NTC sensor.
  • Test the NTC sensor for correct resistance.
  • Replace the control board if the heating relay is defective.
⚠️

Safety Notes

  • Heating components may remain hot after operation.
πŸ“‹

Applicable Models

Show Models
  • EFLS627UTT
  • EFLS527UTT
  • EIFLS60LT
  • EW7F3846QF
  • EW8F2966CB
πŸ“

Related Pages

πŸ“

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

North American EFLS models heat water using the SmartBoost system, so E60 may indicate a SmartBoost heater failure rather than the main drum heater.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.