Frigidaire Washer Error Codes
Below is a complete list of Frigidaire Washer error codes, what each code means, and the issues they typically indicate.
| Error Code | Description |
|---|---|
| E10 | The washer is not filling with water fast enough. |
| E11 | The washer took too long to fill with water. |
| E13 | The washer detected a water leak during filling. |
| E21 | The washer is taking too long to drain. |
| E23 | The drain pump relay on the control board has failed. |
| E24 | The drain pump triac on the control board has failed. |
| E31 | The washer detected a pressure sensor fault. |
| E32 | The pressure sensor is reporting out-of-range values. |
| E33 | The washer detected a mismatch between pressure sensor signals. |
| E35 | The washer detected an excessively high water level. |
| E41 | The washer thinks the door is open. |
| E43 | The control board detected a door‑lock triac failure. |
| E44 | The washer is receiving invalid feedback from the door‑lock switch. |
| E45 | The washer detected a failure in the door‑lock control circuit. |
| E4A | The washer motor cannot reach the required speed. |
| E4E | The washer detected a water temperature sensor fault. |
| E4F | The washer detected a water valve malfunction. |
| E5A | The motor control board overheated. |
| E5B | The washer cannot communicate with the motor control board. |
| E5C | The motor control board has failed. |
| E61 | The washer is not heating water properly. |
| E62 | The washer detected overheating during the heating cycle. |
| E63 | The washer detected a heating relay malfunction. |
| E64 | The washer detected an open circuit in the heating element. |
| E65 | The washer detected a temperature sensor fault. |
| E8C | The washer detected a motor overcurrent condition. |
| E9E | The washer detected low incoming voltage. |
| E9F | The washer detected a communication error between control boards. |
| EA1 | The washer cannot engage the door lock. |
| EA2 | The washer cannot release the door lock. |
| EF1 | The washer detected restricted drainage or a blocked pump filter. |
| EF2 | The washer detected excessive foam. |
| EF3 | The washer detected water in the base pan. |
| EF5 | The washer detected an out‑of‑balance load. |
| ER1 | The washer detected a control board fault. |
| ER2 | The washer detected a keypad or user interface fault. |
| ERd | The washer detected a door-related error. |
| ERH | The washer detected a heating system fault. |
| ERL | The washer cannot lock the door. |
| ERR | The washer detected a general control system fault. |
| ERS | The washer detected a motor speed sensor fault. |