Frigidaire Washer - E11 Error Code

The washer took too long to fill with water.

Meaning

The washer took too long to fill with water.

The Frigidaire E11 error code indicates that the washer did not reach the required water level within the programmed time. Unlike E10, which is a general slow-fill warning, E11 specifically means the water level never reached the pressure sensor target. This is one of the most common Frigidaire washer errors.

Symptoms

  • Washer stalls during fill
  • Water trickles into the drum
  • E11 appears early in the cycle

Causes

  • Clogged inlet screens
  • Low water pressure
  • Faulty pressure sensor
  • Defective inlet valve
πŸ”§

Step-by-Step Fixes

  • Clean inlet screens.
  • Verify household water pressure.
  • Inspect pressure hose for blockages.
  • Replace inlet valve if needed.
⚠️

Safety Notes

  • Disconnect power and water before servicing.
πŸ“‹

Applicable Models

Show Models
  • FAFS4272LW
  • FAFW3801LW
  • ATF7000FS
  • GLTF2940FS
  • FFTW4120SW
πŸ“

Related Pages

πŸ“

Other Frigidaire Washer Error Codes

Show All Error Codes

Model-Specific Notes

On Affinity washers, E11 often appears when detergent residue clogs the pressure chamber.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.