Frigidaire Washer - E23 Error Code

The drain pump relay on the control board has failed.

Meaning

The drain pump relay on the control board has failed.

The Frigidaire E23 error code indicates that the control boardโ€™s drain pump relay is not switching correctly. The washer monitors whether the pump is receiving power when commanded. If the relay is stuck open or closed, E23 is triggered. This error is common on Affinity models with aging control boards.

Symptoms

  • Washer does not drain
  • Pump runs continuously
  • E23 appears during drain

Causes

  • Stuck drain pump relay
  • Burned relay contacts
  • Control board failure
๐Ÿ”ง

Step-by-Step Fixes

  • Inspect control board for burn marks.
  • Test pump voltage during drain.
  • Replace control board if relay is defective.
โš ๏ธ

Safety Notes

  • Disconnect power before accessing control electronics.
๐Ÿ“‹

Applicable Models

Show Models
  • FAFS4272LW
  • FAFW3801LW
  • ATF7000FS
๐Ÿ“

Related Pages

๐Ÿ“

Other Frigidaire Washer Error Codes

Show All Error Codes

Model-Specific Notes

On Affinity washers, E23 often appears alongside E24 when the pump triac is also damaged.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.