Frigidaire Washer - E43 Error Code

The control board detected a door‑lock triac failure.

Meaning

The control board detected a door‑lock triac failure.

The Frigidaire E43 error code indicates that the control board’s door‑lock triac (the electronic switch that powers the lock) is malfunctioning. The triac may be stuck open, stuck closed, or not switching correctly. This prevents the washer from locking or unlocking the door safely.

Symptoms

  • Washer will not start
  • Door lock does not engage
  • E43 appears immediately after pressing Start

Causes

  • Shorted triac on the control board
  • Burned or damaged PCB traces
  • Overcurrent from a failing door‑lock assembly
🔧

Step-by-Step Fixes

  • Inspect the control board for burn marks.
  • Test the door‑lock assembly for shorts.
  • Replace the control board if the triac is defective.
⚠️

Safety Notes

  • Disconnect power before accessing control electronics.
📋

Applicable Models

Show Models
  • FAFS4272LW
  • FAFW3801LW
  • ATF7000FS
📁

Related Pages

📁

Other Frigidaire Washer Error Codes

Show All Error Codes

Model-Specific Notes

On Affinity washers, E43 often appears alongside E45 when the lock circuit overloads the triac.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.