Frigidaire Washer - ER1 Error Code

The washer detected a control board fault.

Meaning

The washer detected a control board fault.

The Frigidaire ER1 error code indicates that the washerโ€™s main control board has failed an internal diagnostic check. This may include memory corruption, processor errors, or damaged circuitry. ER1 is one of the most severe legacy error codes and typically requires board replacement.

Symptoms

  • Washer will not start
  • Display freezes or behaves erratically
  • ER1 appears at startup

Causes

  • Control board failure
  • Power surge damage
  • Corrupted memory
๐Ÿ”ง

Step-by-Step Fixes

  • Power cycle the washer.
  • Inspect the control board for burn marks.
  • Replace the control board if fault persists.
โš ๏ธ

Safety Notes

  • Disconnect power before accessing electronics.
๐Ÿ“‹

Applicable Models

Show Models
  • GLTF2940ES
  • LTF2140FS
  • ATF6000FS
๐Ÿ“

Related Pages

๐Ÿ“

Other Frigidaire Washer Error Codes

Show All Error Codes

Model-Specific Notes

On GLTF washers, ER1 often appears after lightning strikes or major surges.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.