Haier Washer Error Codes
Below is a complete list of Haier Washer error codes, what each code means, and the issues they typically indicate.
| Error Code | Description |
|---|---|
| CLRF | The washer is prompting a control reset or fault clear. |
| E1 | The washer cannot drain water within 4 minutes. |
| E10 | The washer detected a fault requiring service. |
| E11 | The washer is not receiving water. |
| E12 | The washer cannot drain water. |
| E13 | The washer/dryer detected lint buildup or restricted airflow. |
| E2 | The washer cannot lock the door. |
| E4 | The washer did not reach the required water level. |
| E8 | The washer detected an excessively high water level. |
| Err1 | The washer detected that the door is not closed. |
| Err2 | The washer is not draining properly. |
| Err3 | The washer detected abnormal water temperature. |
| Err4 | The washer detected an overflow condition. |
| Err5 | The washer cannot detect that it has filled with enough water. |
| Err6 | The washer detected that the motor is not responding. |
| Err7 | The washer detected a fault requiring service. |
| Err8 | The washer detected a fault requiring service. |
| Err9 | The washer detected a critical internal fault. |
| F3 | The washer detected a temperature sensor fault. |
| F4 | The washer detected a water level sensor fault. |
| F7 | The washer detected a motor circuit error. |
| F9 | The dryer sensor circuit is malfunctioning. |
| FA | The washer detected a water level sensor circuit problem. |
| FC | The washer is not receiving feedback from the driver unit. |
| FC0 | The washer detected a driver communication error (variant 0). |
| FC1 | The washer detected a driver communication error (variant 1). |
| FC2 | The washer detected a driver communication error (variant 2). |
| Fd | The dryer detected abnormal heating. |
| FE | The dryer motor is not operating normally. |
| H | The washer door cannot open because the water is too hot. |
| U3 | The washer detected a spin failure. |
| Unb | The washer detected an unbalanced load. |