Kenmore Washer - F26 Error Code

Door switch not detecting correct position.

Meaning

Door switch not detecting correct position.

The F26 error indicates that the washerโ€™s door switch is not reporting the correct open/closed status. Kenmore explains that this code appears when the control board receives inconsistent or invalid signals from the door switch assembly.

Symptoms

  • Washer will not start
  • Washer displays F26 immediately after pressing Start
  • Door appears closed but washer thinks it is open
  • Intermittent cycle cancellation

Causes

  • Faulty door switch
  • Loose or damaged wiring
  • Misaligned door latch
  • Control board sensor circuit failure
๐Ÿ”ง

Step-by-Step Fixes

  • Inspect door switch wiring.
  • Check latch alignment.
  • Replace door switch if defective.
  • Replace control board if switch circuit is faulty.
โš ๏ธ

Safety Notes

  • Disconnect power before servicing the door switch.
๐Ÿ“‹

Applicable Models

Show Models
  • Kenmore HE3: 110.42822200
  • Kenmore HE3t: 110.44932200
  • Kenmore HE4t: 110.45081400
๐Ÿ“

Related Pages

๐Ÿ“

Other Kenmore Washer Error Codes

Show All Error Codes

Model-Specific Notes

F26 often appears when the door switch harness loosens due to vibration.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.