LG Washer - PE Error Code

The washer detected a water level sensor fault.

Meaning

The washer detected a water level sensor fault.

The LG PE error code indicates that the pressure sensor (water level sensor) is reading out of range or not responding. This code is used across all LG Direct‑Drive washers in North America.

Symptoms

  • Incorrect water level
  • Washer stops mid‑cycle
  • ThinQ may show 'Water level sensor error'

Causes

  • Faulty pressure sensor
  • Blocked pressure hose
  • Loose wiring
  • Control board fault (rare)
🔧

Step-by-Step Fixes

  • Inspect pressure hose for blockages.
  • Check wiring to pressure sensor.
  • Replace pressure sensor if needed.
  • Verify drain hose height to prevent siphoning.
⚠️

Safety Notes

  • Unplug washer before servicing.
📋

Applicable Models

Show Models
  • [Giant-C Giant-V]
  • map[front-load direct-drive:[WM3050CW WM3070HWA WM3170CW WM3370HWA WM3470HVA WM3500CW WM3570HVA WM3600HWA WM3700HWA WM3800HBA WM3900HWA WM4000HWA] top-load direct-drive:[WT7100CW WT7200CW WT7300CW WT7400CV WT7500CW WT7800CW]]
📁

Related Pages

📁

Other LG Washer Error Codes

Show All Error Codes

Model-Specific Notes

- PE and FE can appear together when the pressure hose is blocked. - A pinhole leak in the pressure hose can cause intermittent PE.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.