Maytag Washer - F2E2 (Front-Load) Error Code
User interface (UI) cannot communicate with the main control board.
Meaning
User interface (UI) cannot communicate with the main control board.
The Maytag F2E2 error code on front-load washers indicates that the user interface (UI) has lost communication with the appliance control unit (ACU/CCU). Whirlpool-built Maytag front-load washers use a dedicated serial communication link between the UI and ACU. If this link is interrupted due to a loose harness, failed UI board, corrupted UI firmware, or ACU communication fault, the washer cannot start or continue a cycle and displays F2E2.
Symptoms
Causes
Step-by-Step Fixes
- Unplug the washer for 5 minutes to reset the UI and ACU.
- Remove the top panel and inspect the UI-to-ACU harness for loose or damaged connectors.
- Check the UI ribbon cable for corrosion or poor seating.
- Inspect the UI panel for moisture or detergent residue.
- If wiring is intact, replace the UI control board (most common fix).
- If the error persists after UI replacement, replace the ACU.
Safety Notes
- Disconnect power before accessing internal wiring or control boards.
- Do not operate the washer if moisture is present inside the UI panel.
- Avoid spraying cleaners directly onto the control panel.
Applicable Models
Show Models
- MHW3000 Series: MHW3000BW, MHW3100DW
- MHW3500 Series: MHW3500FW, MHW3505FW
- MHW4200 Series: MHW4200BW
- MHW4300 Series: MHW4300DW
- MHW5100 Series: MHW5100DW
- MHW5500 Series: MHW5500FW, MHW5500DW
- MHW5630 Series: MHW5630HW, MHW5630HC
- MHW6000 Series: MHW6000XW
- MHW6630 Series: MHW6630HW, MHW6630HC
- MHW7000 Series: MHW7000XW
- MHW7100 Series: MHW7100DW
- MHW8200 Series: MHW8200FW
- MHW8630 Series: MHW8630HW, MHW8630HC
- MHW9000 Series: MHW9000YW, MHW9000XL, MHW9000XR
- MHWE Series: MHWE200XW, MHWE201YW, MHWE251YG, MHWE251YW, MHWE301YG, MHWE301YW
- MHWZ Series: MHWZ400TQ, MHWZ600TW
- Commercial Front-Load: MLG2000AWW, MLG3000AWW, MLG4500 Series
Related Pages
- Maytag Washer F1E1 (Front-Load) – Main control board failure --- the ACU/CCU is not functioning correctly.
- Maytag Washer F1E2 (Front-Load) – Motor control board failure --- the MCU is not communicating or functioning correctly.
- Maytag Washer F1E3 (Front-Load) – ACU/MCU configuration mismatch --- the control boards are not synchronized.
- Maytag Washer F6E2 (Front-Load) – Communication error between the user interface (UI) and the motor control system.
Other Maytag Washer Error Codes
Show All Error Codes
- Maytag MVW4505MW Washer Cheat Sheet
- Maytag Neptune TL dc Error Code - Unbalanced Condition
- Maytag Neptune TL Hr Error Code --- Heater Relay Error
- Maytag Neptune TL LE Error Code --- Lid Error
- Maytag Neptune TL LO Error Code --- Locked Rotor
- Maytag Neptune TL OP Error Code --- Lid Open
- Maytag Neptune TL SL Error Code --- Suds Lock
- Maytag Neptune TL UC Error Code --- Uncontrolled Spin
- Maytag Washer CE Error Code - Communication Error
- Maytag Washer dL Error Code - Lock Failure
- Maytag Washer dU Error Code - Unlock Failure
- Maytag Washer F0E1 (Front-Load) Error Code
- Maytag Washer F0E2 (Front-Load) Error Code
- Maytag Washer F0E2 (Top-Load) Error Code
- Maytag Washer F0E3 (Front-Load) Error Code
- Maytag Washer F0E3 (Top-Load) Error Code
- Maytag Washer F0E4 (Front-Load) Error Code
- Maytag Washer F0E4 (Top-Load) Error Code
- Maytag Washer F0E5 (Front-Load) Error Code
- Maytag Washer F0E5 (Top-Load) Error Code
- Maytag Washer F0E7 (Front-Load) Error Code
- Maytag Washer F0E7 (Top-Load) Error Code
- Maytag Washer F0E8 (Top-Load) Error Code
- Maytag Washer F0E9 (Top-Load) Error Code
- Maytag Washer F1E1 (Front-Load) Error Code
- Maytag Washer F1E1 (Top-Load) Error Code
- Maytag Washer F1E2 (Front-Load) Error Code
- Maytag Washer F1E2 (Top-Load) Error Code
- Maytag Washer F1E3 (Front-Load) Error Code
- Maytag Washer F1E3 (Top-Load) Error Code
- Maytag Washer F1E4 (Top-Load) Error Code
- Maytag Washer F1E5 (Top-Load) Error Code
- Maytag Washer F2E1 Error Code --- UI Stuck Button
- Maytag Washer F2E3 (Top-Load) Error Code
- Maytag Washer F2E5 (Top-Load) Error Code
- Maytag Washer F3E1 Error Code --- Water Level System Error
- Maytag Washer F3E2 (Front-Load) Error Code
- Maytag Washer F3E2 (Top-Load) Error Code
- Maytag Washer F3E3 (Front-Load) Error Code
- Maytag Washer F3E3 (Top-Load) Error Code
- Maytag Washer F3E5 (Front-Load) Error Code
- Maytag Washer F3E6 (Front-Load) Error Code
- Maytag Washer F4E1 (Front-Load) Error Code
- Maytag Washer F4E4 (Front-Load) Error Code
- Maytag Washer F5E1 Error Code --- Door or Lid Not Locked
- Maytag Washer F5E2 Error Code --- Door or Lid Not Opened Between Cycles
- Maytag Washer F5E3 Error Code --- Door or Lid Unlock Failure
- Maytag Washer F5E4 (Front-Load) Error Code
- Maytag Washer F5E4 (Top-Load) Error Code
- Maytag Washer F5E5 (Top-Load) Error Code
- Maytag Washer F6E1 Error Code --- Communication Error
- Maytag Washer F6E2 (Front-Load) Error Code
- Maytag Washer F6E2 (Top-Load) Error Code
- Maytag Washer F6E3 (Front-Load) Error Code
- Maytag Washer F6E3 (Top-Load) Error Code
- Maytag Washer F6E4 (Top-Load) Error Code
- Maytag Washer F7E1 Error Code --- Speed Sensor or Motor Speed Error
- Maytag Washer F7E2 (Front-Load) Error Code
- Maytag Washer F7E2 (Top-Load) Error Code
- Maytag Washer F7E3 (Front-Load) Error Code
- Maytag Washer F7E3 (Top-Load) Error Code
- Maytag Washer F7E4 (Top-Load) Error Code
- Maytag Washer F7E5 (Top-Load) Error Code
- Maytag Washer F7E6 (Front-Load) Error Code
- Maytag Washer F7E6 (Top-Load) Error Code
- Maytag Washer F7E7 (Front-Load) Error Code
- Maytag Washer F7E7 (Top-Load) Error Code
- Maytag Washer F7E8 (Front-Load) Error Code
- Maytag Washer F7E8 (Top-Load) Error Code
- Maytag Washer F7E9 (Front-Load) Error Code
- Maytag Washer F7EA (Front-Load) Error Code
- Maytag Washer F7EC (Front-Load) Error Code
- Maytag Washer F8E1 Error Code --- No Fill or Long Fill
- Maytag Washer F8E2 (Front-Load) Error Code
- Maytag Washer F8E2 (Top-Load) Error Code
- Maytag Washer F8E3 (Front-Load) Error Code
- Maytag Washer F8E3 (Top-Load) Error Code
- Maytag Washer F8E5 (Top-Load) Error Code
- Maytag Washer F9E1 Error Code --- Long Drain
- Maytag Washer F9E2 (Top-Load) Error Code
- Maytag Washer F9E3 (Top-Load) Error Code
- Maytag Washer Int Error Code --- Cycle Interrupted
- Maytag Washer LE Error Code --- Motor Error
- Maytag Washer LF or LO FL Error Code --- Long Fill / Low Water Flow
- Maytag Washer LOC or LC Error Code --- Control Lock Activated
- Maytag Washer nd Error Code --- No Drain
- Maytag Washer nF Error Code --- No Fill Detected
- Maytag Washer OL Error Code --- Overload Detected
- Maytag Washer PAU Error Code --- Cycle Paused
- Maytag Washer PF Error Code --- Power Failure
- Maytag Washer rL Error Code --- Items Detected in Clean Washer Cycle
- Maytag Washer Sd or SUD Error Code --- Excess Suds Detected
- Maytag Washer tE Error Code --- Temperature Sensor Error
- Maytag Washer UL Error Code --- Unbalanced Load
Model-Specific Notes
On modern MHW-series front-load washers, F2E2 is most commonly caused by a failed UI board or loose UI-to-ACU harness. On older MHWE and MHWZ models, corrosion on the UI ribbon cable is a frequent cause of communication loss.
Disclaimer
The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.