What are the symptoms of error code LE (TL Variant)?

Washer will not start or continue a cycle, Washer stops mid-cycle with LE on the display, Washer may start, then immediately stop, Washer drains but refuses to spin, Lid must be opened and closed repeatedly to clear the error

What causes error code LE (TL Variant)?

Failing magnetic reed switch, Weak or misaligned lid magnet, Loose or damaged wiring harness to the lid switch, Cracked lid causing magnet misalignment, Moisture intrusion into the switch area, Control board unable to read lid-switch input correctly

How do I fix error code LE (TL Variant)?

Open and close the lid firmly to reset the switch., Inspect the lid hinges for looseness or misalignment., Check the lid magnet (underside of lid, right side) for cracks or weak hold., Test the magnetic reed switch for proper continuity when the lid is closed., Inspect wiring harness connections between the lid switch and control board., Replace the lid switch if continuity is intermittent or unstable., If the switch and magnet test good, inspect the control board input circuit.

Maytag Washer - LE (TL Variant) Error Code

The washer detected a lid switch or lid-position error.

Meaning

The washer detected a lid switch or lid-position error.

The Maytag LE error code (Neptune TL variant) appears only on FAV6800AWW and FAV9800AWW washers. It indicates that the washer detected an invalid or inconsistent lid-position signal. Unlike the OP code, which means the lid is simply open, LE means the control is receiving an impossible or unstable signal from the magnetic reed switch or wiring. This usually points to a failing switch, weak magnet, wiring issue, or intermittent connection.

Symptoms

Washer will not start or continue a cycle
Washer stops mid-cycle with LE on the display
Washer may start, then immediately stop
Washer drains but refuses to spin
Lid must be opened and closed repeatedly to clear the error

Causes

Failing magnetic reed switch
Weak or misaligned lid magnet
Loose or damaged wiring harness to the lid switch
Cracked lid causing magnet misalignment
Moisture intrusion into the switch area
Control board unable to read lid-switch input correctly

🔧

Step-by-Step Fixes

Open and close the lid firmly to reset the switch.
Inspect the lid hinges for looseness or misalignment.
Check the lid magnet (underside of lid, right side) for cracks or weak hold.
Test the magnetic reed switch for proper continuity when the lid is closed.
Inspect wiring harness connections between the lid switch and control board.
Replace the lid switch if continuity is intermittent or unstable.
If the switch and magnet test good, inspect the control board input circuit.

⚠️

Safety Notes

Disconnect power before testing the lid switch or accessing internal wiring.
Do not bypass the lid switch permanently --- this is a safety hazard.
Avoid slamming the lid, which can weaken the magnet or damage the switch.

📋

Applicable Models

Show Models

Maytag Neptune TL: FAV6800AWW, FAV9800AWW

📁

Other Maytag Washer Error Codes

Show All Error Codes

Model-Specific Notes

LE on Neptune TL is almost always caused by a failing reed switch or a weak lid magnet. OP means the lid is open; LE means the signal is invalid or unstable. If the lid must be jiggled or pressed to start a cycle, the switch is failing.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.