What are the symptoms of error code OP?

Washer will not start or continue a cycle, Washer stops mid-cycle and displays OP, Washer drains but will not spin, Washer repeatedly tries to sense lid position, Washer may beep when attempting to resume

What causes error code OP?

Lid not fully closed, Weak or misaligned lid magnet, Failed magnetic reed switch, Broken or loose lid hinge preventing proper alignment, Damaged wiring harness to the lid switch, Control board unable to read lid-switch signal

How do I fix error code OP?

Ensure the lid is fully closed and seated properly., Inspect the lid hinges for looseness or misalignment., Check the lid magnet (right-side underside of lid) for damage or weak hold., Test the magnetic reed switch for continuity when the lid is closed., Inspect wiring harness connections between the lid switch and control board., Replace the lid switch if it fails continuity testing., If the switch and magnet are good, inspect the control board input circuit.

Maytag Washer - OP Error Code

The washer detected that the lid is open.

Meaning

The washer detected that the lid is open.

The Maytag OP error code appears only on Neptune TL washers (FAV6800AWW and FAV9800AWW). It indicates that the washer believes the lid is open when it should be closed. The Neptune TL uses a magnetic reed switch and lid magnet to detect lid position. If the control does not sense the magnet, or if the switch signal is inconsistent, the washer stops and displays OP. This prevents agitation and spin for safety.

Symptoms

Washer will not start or continue a cycle
Washer stops mid-cycle and displays OP
Washer drains but will not spin
Washer repeatedly tries to sense lid position
Washer may beep when attempting to resume

Causes

Lid not fully closed
Weak or misaligned lid magnet
Failed magnetic reed switch
Broken or loose lid hinge preventing proper alignment
Damaged wiring harness to the lid switch
Control board unable to read lid-switch signal

🔧

Step-by-Step Fixes

Ensure the lid is fully closed and seated properly.
Inspect the lid hinges for looseness or misalignment.
Check the lid magnet (right-side underside of lid) for damage or weak hold.
Test the magnetic reed switch for continuity when the lid is closed.
Inspect wiring harness connections between the lid switch and control board.
Replace the lid switch if it fails continuity testing.
If the switch and magnet are good, inspect the control board input circuit.

⚠️

Safety Notes

Disconnect power before testing the lid switch or accessing internal wiring.
Do not bypass the lid switch permanently --- this is a safety hazard.
Avoid slamming the lid, which can weaken the magnet or damage hinges.

📋

Applicable Models

Show Models

Maytag Neptune TL: FAV6800AWW, FAV9800AWW

📁

Other Maytag Washer Error Codes

Show All Error Codes

Model-Specific Notes

The Neptune TL uses a magnetic reed switch mounted under the top deck and a magnet embedded in the lid. Misalignment is extremely common due to hinge wear. If the magnet is weak or the lid flexes, the washer will intermittently trigger OP.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.