Whirlpool Washer Error Codes
Below is a complete list of Whirlpool washer error codes, what each code means, and the issues they typically indicate.
Whirlpool Washer Error Codes
Below is a complete list of Whirlpool Washer error codes, what each code means, and the issues they typically indicate.
| Error Code | Description |
|---|---|
| dET | Detergent cartridge not detected. |
| F0 E1 | Load detected during the Clean Washer cycle. |
| F0 E2 | Oversuds condition detected. |
| F0 E3 | Overload detected. |
| F0 E5 | Off‑balance load detected. |
| F06 | Motor tachometer error. |
| F07 | Motor control unit (MCU) failure. |
| F09 | Overflow condition detected. |
| F1 | Primary control board failure. |
| F1 E1 | Main control board failure. |
| F11 | Serial communication error between CCU and MCU. |
| F14 | EEPROM or memory error. |
| F15 | Motor control unit overheating. |
| F2 | Stuck key or user interface failure. |
| F22 | Door lock failure. |
| F23 | Heater failure detected. |
| F24 | Water temperature sensor error. |
| F25 | Drive motor thermal protector tripped. |
| F26 | Door switch failure detected. |
| F27 | Overflow or pressure switch stuck on 'full'. |
| F28 | Communication error between CCU and MCU. |
| F29 | Door unlock failure. |
| F3 E1 | Water level system error detected. |
| F3 E2 | Temperature sensor (NTC) error. |
| F30 | Dispenser system error. |
| F31 | Pressure switch failure detected. |
| F32 | Pressure switch failure detected. |
| F33 | Pump drive system error. |
| F34 | Water level out of expected range. |
| F35 | Analog pressure sensor failure. |
| F36 | Heater relay failure. |
| F37 | Temperature sensor failure detected. |
| F40 | Water level or pressure system error. |
| F41 | Motor control failure detected. |
| F42 | Motor overcurrent detected. |
| F43 | Motor stalled during operation. |
| F48 | Water temperature out of expected range. |
| F5 | Lid switch or lid lock fault. |
| F5 E2 | Door lock error detected. |
| F5 E3 | Door unlock failure. |
| F51 | Rotor position sensor failure or out-of-range signal. |
| F52 | Motor overload detected. |
| F54 | Motor overheating detected. |
| F6 E3 | Communication error between UI and main control. |
| F7 | Motor unable to start or run. |
| F7 E1 | Motor speed sensing error. |
| F7 E7 | Motor unable to reach target RPM. |
| F72 | Basket re-engagement failure. |
| F73 | Basket disengagement failure. |
| F8 | Water supply or fill error. |
| F8 E1 | No water detected entering the washer. |
| F8 E3 | Overflow condition detected. |
| F83 | Water level calibration error. |
| F84 | Water level sensor reading out of range. |
| F9 | Washer is taking too long to drain. |
| F9 E1 | Long drain time detected. |
| F99 | System fault or control board error. |
| LO FL | Low water flow or no water entering the washer. |
| LOC | Control Lock is activated. |
| SUD | Excessive suds detected in the washer. |
| SUDS | Excessive suds detected in the washer. |