Frigidaire Washer - E32 Error Code

The pressure sensor is reporting out-of-range values.

Meaning

The pressure sensor is reporting out-of-range values.

The Frigidaire E32 error code indicates that the pressure sensor is reporting values outside the expected range. This is similar to E31 but specifically refers to readings that are too high, too low, or inconsistent with the washer’s current state. E32 is more common on older Affinity and Gallery models.

Symptoms

  • Washer stops during fill
  • Water level appears incorrect
  • E32 appears at startup or early in the cycle

Causes

  • Pressure hose blockage
  • Faulty pressure sensor
  • Control board input fault
🔧

Step-by-Step Fixes

  • Clean or replace the pressure hose.
  • Test the pressure sensor.
  • Inspect control board connections.
⚠️

Safety Notes

  • Do not operate the washer with unstable water level readings.
📋

Applicable Models

Show Models
  • ATF6000FS
  • ATF7000FS
  • GLTF2940FS
  • LTF2140FS
📁

Related Pages

📁

Other Frigidaire Washer Error Codes

Show All Error Codes

Model-Specific Notes

On older GLTF models, E32 often appears when the pressure hose becomes brittle and cracks.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Was this page helpful?

Copyright 2026. All rights reserved.